Prof.Dr. Alper ILKI
Structural and Earthquake Engineering
Supervised PhD Thesis
19. Ates, A.O., “Improvement of seismic performance of reinforced concrete columns using glass fiber reinforced mortar with and without textile reinforcement”, Istanbul Technical University, 2022.
18. Demir, U., “Assessment of seismic performance of RC members after fire exposure through large-scale testing”, Istanbul Technical University, 2020 (co-supervised with Prof. Green).
17. Dok, G., “Experimental investigation of the effects of impact damages on the performance of high-strength beams”, Sakarya University, 2020 (co-supervised with Prof. Caglar).
16. Senturk, M., “Developing a bolted moment connection system for precast reinforced concrete frames”, Karadeniz Technical University, 2020 (co-supervised with Prof. Pul).
15. Yilmaz, C., “Experimental investigation of residual load capacity of reinforced concrete beams exposed to impact”, Sakarya University of Applied Sciences, 2019 (co-supervised with Dr. Kirtel).
14. Saribas, I., "Use of environmental-friendly recycled aggregate concrete in production of structural members", Istanbul Technical University, 2019.
13. Dalgic, K.D., "Building response to ground movements induced by tunneling and excavation", Istanbul Technical University, 2018 (co-supervised with Prof. Hendriks).
12.Gurbuz, T., "Impact performance and mitigation of reinforced concrete columns", Queensland University of Technology, 2018 (co-supervised with Prof. Thambiratnam and Prof. Perera).
11.Inci, P., “Field testing and model updating of typical RC buildings for damage identification”, Istanbul Technical University, 2017 (co-supervised with Prof. Catbas).
10.Bas, S., “An investigation on structural identification (St-Id) of a long-span bridge for performance prediction”, Istanbul Technical University, 2017 (co-supervised with Assoc.Prof. Apaydin).
9.Comert, M. “Mevcut betonarme binaların deprem performansları üzerine tam ölçekli bina deneyleri ve modelleme önerileri”, Istanbul Technical University, 2017.
8.Seyhan, E.C., “Improvement of the cyclic flexural capacity of RC columns with FRP reinforcement”, Istanbul Technical University, 2016.
7.Ghatte, H.F., “Seismic retrofit of full-scale rectangular RC columns with low strength concrete by using CFRP wrapping under different axial load”, Istanbul Technical University, 2016.
6.Cosgun, C., “Seismic retrofit of joints of 3D reinforced concrete frames with FRP”, Istanbul Technical University, 2013 (co-supervised with Asst.Prof. Turk).
5.Gunes, B., “Fatique behavior of steel-concrete composite beams strengthened with CFRPs”, Istanbul Technical University, 2013 (co-supervised with Prof. Oztorun).
4.Demir, C., “Seismic behavior of historical stone masonry multi-leaf walls”, Istanbul Technical University, 2012.
3.Goksu, C., “Seismic behavior of RC columns with corroded plain and deformed reinforcing bars”, Istanbul Technical University, 2011.
2.Ispir, M., “A comprehensive experimental research on the behavior of historical brick masonry walls of 19th century buildings”, Istanbul Technical University, 2010.
1.Bedirhanoglu, I., “The behavior of reinforced concrete columns and joints with low strength concrete under earthquake loads: An investigation and Improvement”, Istanbul Technical University, 2009 (co-supervised with Prof. Sozen).
Supervised MSc Thesis
71. Sari, B., “Behavior, modeling and assessment of substandard wide reinforced concrete columns under reversed cyclic loads”, Istanbul Technical University, 2022.
70. Luleci, M.C., “Improvement of earthquake performance of sub-standard reinforced columns using innovative materials”, Istanbul Technical University, 2022.
69. Baltaci, A., “The effect of lap-splice configuration on earthquake performance of sub-standard RC columns under different axial loads”, Istanbul Technical University, 2022.
68. Turgut, A., “Investigation of the performance of proposed models of strength and strain for FRP wrapped concrete of different sizes”, Istanbul Technical University, 2021.
67. Demir, M.N., “Hysteretic response of sub-standard RC columns under high axial stresses and shear demand confined with carbon fiber reinforced polymers”, Istanbul Technical University, 2021.
66.Narlitepe, F., “Seismic strengthening with novel hybrid thin jacketing methods for sub-standard columns exposed to high axial load and shear ratios”, Istanbul Technical University, 2021.
65. Durgut, E., “Investigation of the Bursa Hocaalizade Mosque minaret under different earthquake records with linear and nonlinear analysis approach”, Istanbul Technical University, 2021.
64. Altinok, M.A., “Use of fragility curves for evaluation of different seismic retrofitting techniques applicable to substandard structures”, Istanbul Technical University, 2020.
63. Karakaya, B., “Effect of distribution of material mechanical properties on seismic vulnerability for substandard buildings”, Istanbul Technical University, 2020.
62. Aldirmaz, B., “Investigation of structural health monitoring of a high rise building”, Istanbul Technical University, 2020 (co-supervised with Prof. Kusunoki).
61. Alamehmet, A.Z., “Investigation of the Bursa Grand Mosque Eastern Minaret’s behavior by linear and nonlinear analysis”, Istanbul Technical University, 2019.
60. Kupcu, E., “Fragility analysis of a substandard reinforced concrete structure by using incremental dynamic analysis”, Istanbul Technical University, 2019.
59. Sanver, A.N., “Assessment, repair and in-situ experimental investigation of a reinforced concrete emergency water tower”, Istanbul Technical University, 2019.
58.Unal, G., “Seismic performance of full-scale fire-exposed reinforced concrete columns produced by recycled concrete aggregate”, Istanbul Technical University, 2018.
57.Yildiz, T., “Capturing the damages of a reinforced concrete building that experienced Van earthquake through performance evaluation methods”, Istanbul Technical University, 2016.
56.Uzer, T., “Behaviour of axially loaded RC columns subected to impact loading”, Istanbul Technical University, 2015.
55.Ince, S., “Utilization of recycled concrete in structural members”, Istanbul Technical University, 2015.
54.Khoshkholghi, S., “Strengthening of low-strength short columns with sprayed up textile reinforced GFRC”, Istanbul Technical University, 2015.
53.Baydar, C., “Evaluation of seismic performance and rehabilitation methods for an existing substation structure”, Istanbul Technical University, 2015.
52.Senturk, M., “Seismic retrofit of rectangular RC columns with cross-sectional aspect ratio of three using FRP sheets”, Istanbul Technical University, 2015.
51.Moshfeghi, A., “A new model for plastic hinge length of RC columns and evaluation of seismic assessment documents”, Istanbul Technical University, 2015.
50.Kaya, E., “Enhancement of the flexural behavior of support region of beams under reversed cyclic loads by using advanced material”, Istanbul Technical University, 2014 (co-supervised with Prof. Sheikh).
49.Yilmaz, I.A., “External jacketing of historical walls with basalt fiber mesh reinforced mortar”, Istanbul Technical University, 2014.
48.Karayigit, H., “Evaluation of seismic performance of existing reinforced concrete frame buildings”, Istanbul Technical University, 2014.
47.Guley, E.E., “Effects of details of transverse reinforcement on ductility of lightly confined substandard square and rectangular columns”, Istanbul Technical University, 2014.
46.Nasrinpour, A., “Seismic retrofit of RC columns with sprayed basalt mesh reinforced GRC: Effects of stirrup spacing”, Istanbul Technical University, 2014.
45.Gundogan, S., “Seismic performance analysis of existing reinforced concrete buildings designed according to 1975 Turkish Earthquake Code”, Istanbul Technical University, 2014.
44.Mezrea, P.E., “Retrofitting of historical brick masonry walls with textile reinforced mortar”, Istanbul Technical University, 2014.
43.Vulas, Y., “Rapid performance seismic assessment method (PERA) for existing reinforced concrete frame buildings”, Istanbul Technical University, 2014.
42.Ozcelik, M., “Seismic assessment of existing buildings using PERA, RBTE and DBYBHY-2007”, Istanbul Technical University, 2014.
41.Cavunt, Y., “The interface shear strength of the concrete layers cast at different times: influence of surface preparation”, Istanbul Technical University, 2013.
40.Cavunt, D., “In-situ pullout and shear tests for retrofit anchors in low strength concrete”, Istanbul Technical University, 2013.
39.Saribas, I., “Effects of deficiencies of transverse reinforcement detailing on the behavior of reinforced concrete columns”, Istanbul Technical University, 2013.
38.Ghaffari, P., “Seismic rehabilitation of columns with corroded reinforcing bars through practical interventions”, Istanbul Technical University, 2013.
37.Demir, U., “Axial behavior of high performance fiber reinforced cementitious composites wrapped by FRP sheets”, Istanbul Technical University, 2013.
36.Kalyoncuoglu, A., “Rehabilitation of corrosion damaged substandard RC columns using FRP”, Istanbul Technical University, 2013.
35.Uzunhasanoglu, A., “Anchorage of aramid fiber laminates used for seismic flexural strengthening of reinforced concrete columns”, Istanbul Technical University, 2012.
34.Aydin, A., “Comparison of the observed damage and calculated performance assessment results according to the Turkish
33.Seismic Design Code (2007) for an RC building which exposed to Van earthquake”, Istanbul Technical University, 2012.
32.Inci, P., “Effects of reinforcement corrosion on the seismic performance of RC frame buildings”, Istanbul Technical University, 2011.
31.Okumus, V., “Fatique behavior of steel-concrete composite bridge beams”, Istanbul Technical University, 2011.
30.Ekici, E., “Comparison of observed structural damages and code given structural performance limits”, Istanbul Technical University, 2011.
29.Yilmaz, E., “FRP strengthening of masonary walls constructed with hollow clay bricks and size effects on the observed behavior”, 2010.
28.Dogu, E., “Experimental investigation of the seismic behavior of multi-leaf historical stone walls”, Istanbul Technical University, 2010.
27.Comert, M., “Performance based assessment of reinforced concrete structures against blast loading”, Istanbul Technical University, 2010.
26.Isiltan, O., “Evaluation of performance assessments of DBYBHY2007, Eurocode-8, Fema-356 for reinforced concrete columns considering experimental data”, Istanbul Technical University, 2010.
25.Dalgic, D.K., “Behavior and finite element analysis of concrete confined by low modulus FRP”, Istanbul Technical University, 2010.
24.Yilmaz, H., “The effect of lap splice length of longitudinal bars on the performance of low strength reinforced concrete members under lateral loads”, Istanbul Technical University, 2009.
23.Yildiz, H., “Investigating the effects of lap spliced low strength reinforced concrete columns on structural performance under different axial loads”, Istanbul Technical University, 2009.
22.Polat, A., “Flexural strengthening of low strength reinforced concrete members with plain bars by using fiber reinforced polymer reinforcement”, Istanbul Technical University, 2009.
21.Kolcu, K., “Effects of loading rate on axial behavior of concrete confined by fiber reinforced polymer”, Istanbul Technical University, 2008.
20.Gedik, O., “Comparison of proposed models of strength and strain for FRP wrapped concrete”, Istanbul Technical University, 2008.
19.Demirtas, B., “The effect of corrosion on reinforced concrete columns in regards of seismic performance”, Istanbul Technical University, 2008.
18.Gurbuz, T., “Pull-out performance of retrofit adhesive anchors”, Istanbul Technical University, 2007.
17.Incecik, O., “Seismic behavior of beam-column connections of reinforced concrete structures”, Istanbul Technical University, 2007.
16.As, F., “Retrofitting of historical masonary walls with FRP composites”, Istanbul Technical University, 2007.
15.Basegmez, I.H., “Seismic retrofit of shear deficient reinforced concrete short columns with FRP composites”, Istanbul Technical University, 2007.
14.Candan, Y., “Strengthening of low strength concrete panels using innovative materials”, Istanbul Technical University, 2007.
13.Kaya, Y., “Pull-out behaviour of partially bonded anchors to be used in retrofitting existing structures under different anchorage interface conditions”, Istanbul Technical University, 2007.
12.Seyhan, E.C., “Behavior of Chemical Anchors”, Istanbul Technical University, 2006.
11.Akgun, D., “Low strength concrete members retrofitted with high performance fiber reinforced cementitious composite (HPFRCC) panels”, Istanbul Technical University, 2005.
10.Goray, R.O., “Axial behavior of concrete members retrofitted with HPFRCC panels”, Istanbul Technical University, 2005.
9.Peker, O., “Low strength reinforced concrete members strengthened with CFRP sheets”, Istanbul Technical University, 2005.
8.Karamuk, E., “Axial Behavior of Reinforced Concrete Columns Strengthened with Carbon Fiber Reinforced Polymers”, Istanbul Technical University, 2005.
7.Kozbay, T., “Behavior of Reinforced Concrete Columns Retrofitted with Prefabricated HPFRCC Panels”, Istanbul Technical University, 2005.
6.Sarmanli, C., “Behavior of Reinforced Concrete Columns Retrofitted with Steel Tubes”, Istanbul Technical University, 2005.
5.Tezcan, A., “Retrofit of Column Confinement zones with CFRP Composites”, Istanbul Technical University, 2004.
4.Yılmaz, E., “Column Retrofit with Prefabricated SFRC Panels”, Istanbul Technical University, 2004.
3.Demir, C., “Behavior of Jacketed Damaged Reinforced Concrete Members Subjected to Reversed Cyclic Loads”, Istanbul Technical University, 2004.
2.Koc, V., “Behavior of Low and Medium Strength Concrete Members Strengthened with Carbon Fiber Reinforced Polymers”, Istanbul Technical University, 2004.
1.Yagcioglu, A.A., “Structural Analysis of an Existing Building and Evaluation of the Building using Seismic Index Method”, Istanbul Technical University, 2003.